General Safety Rules; Stop Functions - SEMAK HCD05 Operation And Warranty Booklet

3. SAFETY

3.1. General safety rules

Carefully read the whole instruction manual.
The connection to the electricity mains must comply with the current safety
standards in the user's country.
The machine must be connected to an electric outlet that is:
compatible with the plug provided with the machine;
of dimensions conforming to the data shown on the rating plate on the
side of the machine;
properly grounded;
connected to a system provided with a differential switch and circuit break-
er;
connected to a system that has been certified according to the current
standards and regulations in the country of use.
The power cord must not be:
allowed to come into contact with any kind of liquid: danger of electric
shocks and/or fire;
crushed and/or brought into contact with sharp surfaces;
used to move the machine;
used if it shows any damage;
handled with damp or wet hands;
wound into a coil when the machine is on.
tampered with.
04/2010
Do not clean the machine with gasoline and/or solvents of any kind.
Repair work may be performed only by a Service Center authorized by the
Manufacturer and/or specialized, trained personnel.
Do not site the machine near heating equipment (stoves or radiators).
ln case of fire, use carbon dioxide (CO2) extinguishers. Do not use water or
powder extinguishers.
In the event of improper use, all warranty rights will be forfeited
an d the manufacturer will accept no liability for injury or dam-
age to perso ns and/or property.
The following are to be considered improper use:
- any use other than the intended use and/or with methods other than those
described herein;
- any operation on the machine that is in contrast with the directions provided
herein;
- use of the machine after any components have been tampered with and/or
safety devices have been changed;
- use of the machine after it has undergone repair with components not au-
thorized by the manufacturer;
- outdoor installation of the machine.

3.2. Stop functions

The machine is shut down by turning off the on/off switch.