Electrolux 300 Series Use & Care Manual page 15

6. Tighten by
hand until snug.
Then tighten
each supply
connection
another 2/3 turn
with pliers. Do not bend, kink or pinch
water inlet hoses.
7. Turn on the water
and check for leaks.
Connecting the drain
1. Verify the anti-
siphon disc is in
place.
2. Form a "U" shape
on the end of the
drain hose with
the hose pointed
toward the drain.
Place the formed
end in a laundry
tub or a standpipe and secure the
drain hose with the cable tie (provided
in the manual bag) to the standpipe,
inlet hose, laundry tub, etc. so the hose
does not pull out from the force of the
water.
Cable Tie
IMPORTANT
Check to ensure the power is off at a
circuit breaker/fuse box before plugging
the power cord into an outlet.
Anti-Siphon
Disc
Insert Less
Than 8.5"
(21.5 cm)
INSTALLATION

NOTE
The standpipe inside diameter must be
1-1/4" (3.2 cm) minimum. There must be
an air gap around the drain hose in the
standpipe. A snug hose fit can cause a
siphoning action.
Completing the installation
1. Plug the power cord into a grounded
outlet.
WARNING
ELECTRICAL SHOCK HAZARD
Improper connection of the equipment
grounding conductor can result in a risk
of electrical shock. Check with a licensed
electrician if you are in doubt as to whether
the appliance is properly grounded.
2. Turn on the power at a circuit breaker/
fuse box.
3. Carefully slide the washer to its final
position. Recheck for level and rock
corners for stability. See Leveling the
washer. Remove and discard door
tape.
4. Run the washer through a complete
cycle, checking for water leaks and
proper operation.
5. If you have any questions during
initial operation, please review the
Troubleshooting section before calling
for service.
6. Place these instructions in a location
near the washer for future reference.

NOTE
A wiring diagram and technical data
sheet are located under the washer top
panel, on top of the detergent dispenser
housing.
15