Electrolux 300 Series Use & Care Manual page 41

4. Rinse the drawer and inserts with
hot tap water to remove traces of
accumulated powders and liquids.
Large amounts of fabric softener
residue may indicate improper dilution
or more frequent cleaning is required.
5. To clean the drawer opening, use
a small brush to clean the recess.
Remove all residue from the upper and
lower parts of the recess.
6. Replace the insert by pressing it in
place until you hear a slight click.
7. Return the dispenser drawer to the unit.
Cleaning the Adaptive Dispenser™
1. Remove the drawer by pulling the
dispenser out until it stops.
2. Reach back into the right rear corner
of the dispenser cavity and press down
firmly on the lock tab. Pull out the
dispenser drawer.
CARE AND CLEANING
3. Remove the detergent cup and top
cover from the dispenser drawer.
4. Remove the bottom cover from the
dispenser drawer.
a) First, pull the two lock tabs at the rear
of the dispenser drawer to unlatch the
back cover.
b) Then, gently pull back the two clips on
the front of the bottom cover to fully
release it from the dispenser drawer.
5. Rinse the dispenser drawer, covers, and
detergent cup with hot tap water to
remove traces of accumulated powders
and liquids. Large amounts of fabric
softener residue may indicate improper
dilution or more frequent cleaning is
required.
6. To clean the dispenser drawer
opening, use a small brush to clean
the recess. Remove all residue from the
upper and lower parts of the recess.
7. Reassemble dispenser drawer and
check to ensure that all pieces are
securely in place.
8. Return the dispenser drawer to the unit.
41