Indicators Problems; Warning Messages; Messages List - Sony VPL-EW5 Operating Instructions Manual

Remote Commander
Symptom
The Remote Commander
does not work.
Others
Symptom
The control panel keys do
not function.
Indicators
Symptom
The LAMP/COVER
indicator flashes in orange.
(Repetition rate of 2
flashes)
The LAMP/COVER
indicator flashes in orange.
(Repetition rate of 3
flashes)
/
: 1 key flashes in red.
(Repetition rate of 2
flashes)
/
: 1 key flashes in red.
(Repetition rate of 4
flashes)
/
: 1 key flashes in red.
(Repetition rate of 6
flashes)

Messages List

Warning Messages

Use the list below to check the meaning of the messages displayed on the screen.
Message
Please replace the Lamp
and clean the Filter.
Cause and Remedy
The Remote Commander battery are dead.
c Replace them with new battery (see page 16).
Cause and Remedy
The control panel keys are locked.
c Unlock the control panel keys (see page 36).
Cause and Remedy
• The lamp cover or the air filter cover is detached.
c Attach the cover securely (see pages 43 and 44).
• The lamp has reached the end of its life.
c Replace the lamp (see page 42).
• The lamp has reached a high temperature.
c Wait for 60 seconds to cool the lamp and then turn on the power
again.
• The internal temperature is unusually high.
c Check to see that nothing is blocking the ventilation holes.
• The projector is being used at a high altitude.
c Ensure that "High Altitude Mode" in the Setup menu is set to
"On."
The fan is broken.
c Consult with qualified Sony personnel.
Unplug the AC power cord from the wall outlet after the :/1 key
stops flashing, plug the power cord to the wall outlet, and then turn
the projector on again. If the ON/STANDBY flashes in red and the
problem persists, the electrical system has failed.
c Consult with qualified Sony personnel.
Meaning and Remedy
• It is time to replace the lamp and clean the air filter.
c Replace the lamp (see page 42) and clean the filter (see
page 44).
• When this message appears even after replacing the lamp, the task
has not been completed.
c Perform the operation of steps 10 to 13 on page 43
47
Troubleshooting