Gasket Replacement; Secondary Air Manifold Replacement - Napoleon 1400ML Installation And Operating Instructions Manual

8.6

GASKET REPLACEMENT

At the end of each burning season inspect the shield
below the secondary air manifold for warping or
deterioration. Replace if necessary. Both are held to
the manifold with machine screws. The shield and
the 1/8" (3mm) fibre cloth gasket are available from
your local authorized dealer/distributor. At this time
also check that the door gasket is not worn or loose.
Replace with 1/2" (13mm) high density fibreglass
rope if necessary.
The airwash gasket and shield located inside the
appliance above the door should also be inspected
and replaced if deteriorated.
NOTE: Do not operate appliance if the
manifold shield, airwash shield or fibre baffle is
deteriorated or missing.
8.7

SECONDARY AIR MANIFOLD REPLACEMENT

At the end of each burning season inspect the secondary air manifold for warping or deterioration. Replace if
necessary. At this time also check that the door gasket is not worn, frayed or loose. Replace with 1/2" (13mm)
high density fibreglass rope if necessary. Check the airwash gasket located inside the appliance above the
door, replace if deteriorated. Contact your Napoleon dealer for specific type and size of the materials required.
NOTE: Do not operate appliance if the manifold, airwash shield or fibre baffle is deteriorated or missing.
To remove the secondary air manifold follow these instructions:
Remove the screws securing the side shields, slide
A.
them forward and remove from the appliance.
Remove the screws securing the rear shield, then
B.
remove the shield from the appliance.
Remove the rear bricks, then remove the baffle.
C.
Remove the 2 nuts and bolts securing the
D.
secondary air manifold in place, refer to the
illustration below.
Remove the secondary air manifold and gasket.
E.
AIRWASH
SHIELD AND
GASKET
A
B
1400 ILLUSTRATED
29
EN
W415-1467 / C / 08.20.18