Care Of Glass; Door Gasket Replacement - Napoleon S20-1 Installation And Operation Manual

maintenance
EN
7.6

care of glass

WARNING
!
• Do not clean glass when hot! Do not use abrasive cleaners to clean glass.
If the glass is not kept clean, permanent discolouration and/or
blemishes may result. Normally a hot fi re will clean the glass. The
most common reasons for dirty glass include:
• Not using suffi cient fuel to get the appliance thoroughly hot.
• Using green or wet wood.
• Closing the draft so far that there is insuffi cient air for complete
combustion.
If it is necessary to clean the glass, buff lightly with a clean dry cloth and non-abrasive cleaner. Clean the glass
after the fi rst 10 hours of operation with a recommended appliance glass cleaner. Thereafter, clean as required.
The glass is very strong, but do not let burning fuel rest or fall against it and always close the door gently.
NEVER FORCE OR SLAM IT SHUT!
Do not operate the appliance with broken glass, as leakage of fl ue gases may result.
Contact your local authorized dealer/distributor for complete cleaning instructions.
If the glass should ever crack or break while the fi re is burning, do not open the door until the fi re is out. Do not
operate the appliance until the glass has been replaced. Contact your local authorized dealer/distributor for
replacement parts. DO NOT SUBSTITUTE MATERIALS.
7.7

door gasket replacement

1. When the appliance is cool, remove the door and
place it face down on a soft, non-abrasive surface
(see "door removal" section). Be careful not to
scratch the paint.
2. Apply high temperature silicone (not supplied) in
the gasket groove as illustrated (Fig. 7-4).
3. Cut the 1/2" gasket (supplied) to size and place on
top of the silicone. Press the gasket down fi rmly to
ensure it stays in place. Ensure the gasket joint is at
the bottom as illustrated (Fig. 7-4).
4. Re-install the door.
34
W415-2796 / B / 12.19.19
WARNING
!
High Temperature
Silicone
1/2" Gasket
HOT GLASS WILL CAUSE
BURNS.
DO NOT TOUCH GLASS UNTIL
COOLED.
NEVER ALLOW CHILDREN TO
TOUCH GLASS.
Gasket Joint
Fig. 7-4