Table of Contents
Advertisement
en Troubleshooting
Fault
The programme does
not start.
The door cannot
be opened.
The water is not drain-
ing.
54
Cause and troubleshooting
Close the door.
3.
Press Start/Reload to start the programme.
4.
The detergent drawer has not been pushed in as far
as it can go.
Push the detergent drawer in as far as it will go.
▶
The pump for the intelligent dosing system is blocked.
Switch off the appliance.
1.
Clean the pump unit.
2.
→ "Cleaning the detergent drawer", Page 44
If this indicator appears again, call our after-sales
3.
service.
→ "Customer Service", Page 63
Note: You can start the washing programme if you de-
activate the intelligent dosing system and dose manu-
ally.
→ "Buttons", Page 23
- - - - is activated.
Continue the programme by selecting Spin or
▶
Drain and pressing Start/Reload.
→ "Resuming the programme when the programme
status is Rinse Hold", Page 39
The temperature is too high.
Wait until the temperature has dropped.
▶
→ "Cancelling the programme", Page 39
▶
Water level is too high.
Start the Drain programme.
▶
Power failure.
Open the door using the emergency release.
▶
→ "Emergency release", Page 61
Drain pipe or water outlet hose is blocked.
Clean the drain pipe and the water outlet hose.
▶
Drain pipe or water drain hose is caught or jammed.
Ensure that the drain pipe and water drain hose are
▶
not kinked or trapped.
Drain pump is blocked.
→ "Cleaning the drain pump", Page 46
▶
- - - - is activated.
Advertisement
Table of Contents
