Download Print this page

Installation - Whirlpool AGG640IX Instruction Manual

Advertisement

Installation

Installation place conditions
1. The use of the gas ranges produce heat and humidity where are installed.
2. Good room ventilation is essential for safe operation of your appliance, all rooms require an open able
window, equivalent or permanent vent. So that the air for combustion is taken from air and the exhaust gases
are emitted directly into the room. The appliance need enough space, if they will be located in a kitchen or bed-
sitting room which containing a bath or shower. Don't install this appliance in the room below.
Room size
s
m
a
l l
r e
h t
a
n
5
m
5m³ to 10m
greater than 10m³' den
In the cellar or basement
"this appliance is not connected to a combustion products evacuation device. It shall be installed and
connected in accordance with current installation regulations. Particular attention shall be given to there levant
requirements regarding ventilation
"!CAUTION:" The use of agas cooking appliance results in the production of heat, moisture and products of
combustion" in the room in which It is installed. Ensure that the kitchen is well ventilated especially when the
appliance is in use": keep natural ventilation holes open or install a mechanical ventilation device(mechanical
extractor hood).
Prolonged intensive use of the appliance may call for additional ventilation, for example opening of a window,
or more effective ventilation, for example increasing the level of mechanical ventilation where present".
3.
If the gas range will be working for a long period of time an extra ventilation will be necessary to increase the
.
air flow
4.
Air draft should not decrease the good performance of the gas range or cut the gas flame
. 5
Do not install the range on top of carpets Do not install the range near the refrigerator as the
excessive heat.
The heat emitted by the product will increase the energy consumption of cooling
appliances.
Gas range installation
1.
90
Leave at least
cm between the top of the gas range and any cabinet or range hood install above prepared
.
to be installed built in
2.
2
Leave at least cm in the back and each side of the gas range to allow the heat to get out
. 3
Make sure not to block the oven gas exit including the funnel or the gas vents when you install the oven
Gas installation
prior to installation, ensure that the local distribution conditions(nature of the gas and gas pressure) and the
adjustment of the appliance are compatible";
DANGER
Product can be connected to gas supply system only by an authorized and qualified person.
Risk of explosion or toxication due to unprofessional repairs!
Manufacturer shall not be held responsible for damages arising from procedures carried out by
unauthorized persons.
DANGER
Before starting any work on the gas installation, disconnect the gas supply.
There is the risk of explosion!
Gas installation must be prepared before installing the product.
If necessary, interchange the sharp hose tip and the blind plug at the rear of your oven by selecting a
suitable place on basis of the location of the natural gas valve.
1
³
,
Ventilation opening
m
n i
1 .
0
0
c
min.50cm²
not required
min.65cm²
,
.
2
1 Blind plug
2 Hose tip
5
m
²
.
.
,
,
.

Advertisement

loading