Advertisement
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Observe all governing codes and ordinances.
Required:
■
A 120 Volt, 60 Hz, AC only, 15- or 20-amp electrical supply
with a fuse or circuit breaker.
Recommended:
■
A time-delay fuse or time-delay circuit breaker.
■
A separate circuit serving only this microwave oven.
Clock
The Clock is a standard 12-hour (12:00-11:59) clock. Touch
CLOCK, enter time, then touch CLOCK or the Start control.
Kitchen Timer
The kitchen timer can be used independently during any cooking
program. Touch the Timer control, enter time, then touch the Timer
control or the Start control.
Vent Fan
High, low and off. Comes on automatically as cooling fan during
any cook function.
Cooktop Light
High, low and off. Low setting may be used as night light.
Electrical Requirements
■
For all cord connected appliances:
The microwave oven must be grounded. In the event of
an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current. The microwave oven is equipped with a cord
having a grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly installed
and grounded.
WARNING:
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the grounding instructions are
not completely understood, or if doubt exists as to whether
the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord is
too short, have a qualified electrician or serviceman install
an outlet near the microwave oven.
This device complies with Part 18 of the FCC Rules.
Settings
Control Lock
Activate to avoid unintended start. Depending on your model, the
padlock graphic on the control panel is next to either the Start
control or Cancel control. Touch and hold the appropriate control
pad for about 5 seconds until 1 tone sounds and padlock icon
appears in the display. Repeat to unlock control.
Tones
Programming tones and signals. Touch and hold number pad "1"
for about 5 seconds to turn off programming tones. Repeat to turn
back on. Touch and hold number pad "2" for 5 seconds to turn off
all tones. Repeat to turn back on.
Demo Mode
Activate to practice using the control without actually turning on
the magnetron. Touch and hold the Timer control for 5 seconds.
The "d" will appear in the display. Repeat to exit Demo Mode.
GROUNDING INSTRUCTIONS
Improper use of the grounding plug can
SAVE THESE INSTRUCTIONS
3
Advertisement
