Advertisement
For more information contact our team: service.ec@foagroup.com
ASSEMBLY RATING
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
EASY
Assembly Instructions
CM7389EK
DIFFICULT
R
Tools Required For Assembly:
Allen Wrench
Wrench
Phillips Screwdriver
2 PERSONS RECOMMENDED
Page 1 of 7
R
(Included)
(Included)
(Not Included)
REV: 18-01-10
Advertisement
Table of Contents
Related Manuals for Furniture of America CM7389EK
Summary of Contents for Furniture of America CM7389EK
- Page 1 Assembly Instructions For more information contact our team: service.ec@foagroup.com CM7389EK ASSEMBLY RATING Tools Required For Assembly: The Assembly Rating is a 5-point system that Allen Wrench shows the degree of effort needed in (Included) assembling a specific product (with 1 being Wrench easy and 5 being difficult).
- Page 2 LOOSEN OVER TIME AND MAY CAUSE THE FURNITURE TO BE WOBBLY AND UNABLE TO SUPPORT ITS INTENDED WEIGHT CAPACITY. THIS MAY LEAD TO COLLAPSE AND MAY CAUSE SERIOUS INJURY. FAILURE TO FOLLOW THE GUIDELINES ABOVE MAY RESULT IN INJURY AND/OR PROPERTY DAMAGE. FURNITURE OF AMERICA.ALL RIGHTS RESERVED. Page 2 of 7...
- Page 3 Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed. #A x 1pc #1 x 1pc Allen Key M4 Headboard #B x 8pcs #2 x 2pcs Bolt Ø5/16 x 1-3/4"...
- Page 4 Exploded View Attach bun foot (#3) to the holes of the headboard posts (#2). Page 4 of 7...
- Page 5 1) Attach threaded bolts (#E) to the holes of the HB posts (#2R/L), then align headboard (#1) to HB posts (#2R/L). Secure by using washer (#F) and hex nut (#G) onto threaded bolts (#E). #B x 6 pcs #C x 6 pcs #D x 6 pcs #E x 2 pcs #F x 2 pcs...
- Page 6 Attach support legs (#8) to the holes of the slats (#7), then adjust levelers of the support legs (#8) according to ground level. Leveler Attach bun foot (#3) to the holes of the footboard (#4). Page 6 of 7...
- Page 7 Attach side rails (#5) by hooking side rails (#5) to the latches of the headboard (#1) and footboard (#4). Make sure it is firmly in place. Align slats (#7) to the side rails (#5), then secure by using screws (#I). #I x 10 pcs Page 7 of 7...
Need help?
Do you have a question about the CM7389EK and is the answer not in the manual?
Questions and answers