Power Supply - Panasonic Palmcorder PV-GS59 Operating Instructions Manual

Using the Remote Control
(PV-GS59 Only : Optional)
1
Direct the Remote Control at the Remote
Control Sensor of the Camcorder and
press an appropriate button.
15°
15°
15°
15°
• Distance from the Camcorder: Within
approximately 15 feet (5 meters)
• Angle: Within approximately 15° in the vertical
and horizontal directions from the central axis
• The above operating ranges are for indoor use.
Outdoors or under strong light, the Camcorder may
not operate properly even within the above ranges.
Selecting Remote Control Modes
When 2 Camcorders are used simultaneously,
they can be operated individually by selecting
different Remote Control Modes.
• If the Remote Control Mode of the Camcorder
and that of the Remote Control do not match
with each other, [REMOTE] will appear. When
the Remote Control is operated for the first
time after the Camcorder is turned on, [CHECK
REMOTE MODE] (p. 71) will appear and
operation is impossible. Set the same Remote
Control Mode.
Setup on the Camcorder
Set [ REMOTE] on the [
the desired Remote Control Mode. (pp. 27, 28)
Setup on the Remote Control
2
[VCR1]:
Press the [Ι►] Button and [ ■ ] Button
simultaneously.
1
[VCR2]:
Press the [◄Ι] Button and [ ■ ] Button
simultaneously.
2
• When the battery in the Remote Control is
replaced, the mode is automatically reset to [VCR1]
Mode.
SETUP] Sub-Menu to
1

Power Supply

Using the AC Adaptor
• Before connecting or disconnecting the
power supply, set the [OFF/ON] Switch on
the Camcorder to [OFF] and make sure that
[STATUS] Indicator is not lit. (p. 20)
1
Connect the DC Cable to the Camcorder.
2
Connect the DC Cable to the AC Adaptor.
3
Connect the AC Cable to the AC Adaptor
and the AC Jack.
2
Using the Battery
Before use, fully charge the Battery.
• We recommend using a Panasonic Battery.
• We cannot guarantee the quality of this Camcorder
when batteries from other companies are used.
1
Attach the Battery to the AC Adaptor and
charge it.
2
Put the Battery on the Battery Mount by
aligning the mark, and then securely plug
it in.
1
3
15