Table of Contents
Advertisement
Removing tableware
WARNING
Risk of injury!
Hot tableware can cause burns to the
skin. When hot, tableware is sensitive
to shock, may crack and can result in
injury.
When the programme has ended,
▶
do not empty the appliance until
the tableware has cooled down for
a while.
To prevent water dripping on the
1.
tableware, unload it starting at the
bottom and working up.
Check the washing tank and ac-
2.
cessories for soiling and clean if
necessary.
→ "Cleaning and servicing",
Page 41
Basic operation
Basic operation
You can find out everything you need
Basic operation
to know about operating your appli-
ance here.
Opening appliance door
Open the appliance door.
▶
Switching on the appliance
Press
.
▶
The Eco 50° programme is set by
default.
The Eco 50° programme is an es-
pecially environmentally friendly
programme and ideal for normally
soiled tableware. It is the most effi-
cient programme for the combina-
tion of energy/water consumption
for this type of tableware and evid-
ences conformity with the EU Eco-
design Directive.
If you do not perform any actions
on the appliance for 10 minutes,
the appliance will automatically
switch off.
Setting a programme
To adjust the wash cycle to the soil-
ing level of the tableware, select a
suitable programme.
Press the right programme button.
▶
→ "Programmes", Page 19
a The programme is set and the pro-
gramme button flashes.
Setting additional functions
You can set additional functions to
complete the washing programme
selected.
Note: The additional functions which
can be used depend on the pro-
gramme selected.
→ "Programmes", Page 19
Press the button for the relevant
▶
additional function.
→ "Additional functions", Page 21
a The additional function is set and
the additional function button
flashes.
Setting timer programming
You can delay the start of the pro-
gramme by up to 24 hours.
Press
.
1.
Press
or
2.
display shows the right time.
Depending on the setting of the
time display, the end of the pro-
gramme is shown on the display
either with "Finish in" (e.g.
3h 25min) or "Finish at" (e.g.
15:20 hours). You can change this
setting in the "Basic settings"
→ Page 37.
Basic operation en
repeatedly until the
35
Advertisement
Table of Contents
