The Radio: Manual Tuning; The Radio: Preset Tuning - Panasonic SC-AK100 Operating Instructions Manual

The radio: manual tuning

1
3
1
Press [TUNER/BAND] to select band.
The unit comes on.
Every time you press the button:
FM AM
2
Press [PLAY MODE] on the remote control to select
"MANUAL".
Every time you press the button:
MANUAL PRESET
3
Hold down [g/REW/3] or [4/FF/f] for a moment
to search for a station.
The frequency stops when it finds a clear station.
To stop during the process, press [g/REW/3] or [4/FF/f].
Under excessive interference, a station may not be found.
Press [g/REW/3] or [4/FF/f] repeatedly to tune step-by-
step.
"TUNED" is displayed when a radio station is tuned.
"ST" is displayed when a stereo FM broadcast is being
received.
If noise is excessive in FM
Remote control only
Hold down [PLAY MODE] to display "MONO"
Monaural sound is selected and noise reduces when reception is
weak.
Hold down [PLAY MODE] again to cancel the mode.
"MONO" is also cancelled if the frequency is changed.
To receive FM broadcasts allocated in 0.1MHz steps
Main unit only
Hold down [TUNER/BAND]. The display changes in a few seconds to
show the current minimum FM frequency. Continue to hold down the
button until the minimum frequency changes. The step is changed.
Changing the step erases all preset stations.
Repeat the above to change the step back.
Notes
•
After changing the "allocation" setting, the frequencies you previously
preset in the memory will be cleared.
•
Sound is momentarily interrupted if you load/unload tapes while
listening to an AM broadcast.
Remote control only
There are two methods of pre-setting stations.
Automatic presetting : All the stations the tuner can receive are
Manual presetting
2
Up to 15 stations each can be set in the FM and AM bands.
Numbered buttons
Preparation:
Press [TUNER] to select "FM" or "AM".
Do the following once each for FM and AM.
Preparation: Tune to the frequency where pre-setting is to begin.
Hold down [PROGRAM] until the frequency changes.
The tuner presets all the stations it can receive into the channels in
ascending order. When finished, the last station memorized is tuned
in.
Pre-set the stations one at a time.
1 Press
.
2 Press
3 Press [PROGRAM].
The station occupying a channel is erased if another station is preset
in that channel.
Press the numbered buttons to select the channel.
To enter channel 10 or over, press [ 10], then the two digits.
1 Press [PLAY MODE] to select "PRESET".
2 Press [g/REW/3] or [4/FF/f] to select the

The radio: preset tuning

preset.
: You can select the stations to preset and the
order they are preset in.
PLAY MODE
TUNER
Automatic presetting
Manual presetting
[PROGRAM] then
[4/ FF/f] to tune to the desired station.
[PROGRAM] then
[4/ FF/f] to select a channel.
Selecting channels
OR
channel.
PROGRAM
press [g/REW/3 ] or
press [g/REW/3 ] or
7
RQT6351