The Radio: Manual Tuning; The Radio: Preset Tuning - Panasonic SC-VK31 Operating Instructions Manual

The radio: manual tuning

3
1
Press [TUNER, BAND] to select band.
The unit comes on.
Every time you press the button:
FM ↔ AM
2
Press [PLAY MODE] on the remote control to select
"MANUAL".
Every time you press the button:
MANUAL ↔ PRESET
Hold down [ g g g g /REW/3 3 3 3 3 ] or [4 4 4 4 4 /FF/f g
3
to search for a station.
The frequency stops when it finds a clear station.
To stop during the process, press [g/REW/3] or [4/FF/f].
Under excessive interference, a station may not be found.
Press [g/REW/3] or [4/FF/f] repeatedly to tune step-by-
step.
"TUNED" is displayed when a radio station is tuned.
"ST" is displayed when a stereo FM broadcast is being received.
If noise is excessive in FM
Remote control only
Hold down [PLAY MODE] to display "MONO".
Monaural sound is selected and noise reduces when reception is
weak.
Hold down [PLAY MODE] again to cancel the mode.
"MONO" is also cancelled if the frequency is changed.
12
RQT7704
Remote control only
There are two methods of pre-setting stations.
Automatic presetting : All the stations the tuner can receive are
Manual presetting
Up to 15 stations each can be set in the FM and AM bands.
3
f ] for a moment f f f
Preparation:
Press [TUNER/AUX] to select "FM" or "AM".
Do the following once each for FM and AM.
Preparation: Tune to the frequency where pre-setting is to begin.
Hold down [PROGRAM] until the frequency changes.
The tuner presets all the stations it can receive into the channels in
ascending order. When finished, the last station memorized is tuned in.
Pre-set the stations one at a time.
1 Press [PROGRAM] then press [( REW] or [) FF] to tune
2 Press [PROGRAM] then press [g 3] or [f 4] to select
3 Press [PROGRAM].
The station occupying a channel is erased if another station is preset
in that channel.
Press the numbered buttons to select the channel.
To enter channel 10 or over, press [>10], then the two digits.
1 Press [PLAY MODE] to select "PRESET".
2 Press [g 3] or [f 4] to select the channel.

The radio: preset tuning

preset.
: You can select the stations to preset and the
order they are preset in.
Automatic presetting
Manual presetting
to the desired station.
a channel.
Sele cting channels
OR