Table of Contents
Advertisement
Adjusting speaker level
Volume (Channel balance) (
(Effective when playing multi-channel audio)
1
Select "Test" and press [OK].
A test signal is output.
2
While listening to the test signal
Press [3, 4] to adjust the volume of each
speaker.
The volume can be adjusted between r6 dB to s6 dB.
≥ Set each speaker level according to the volume of the
Front (L) and Front (R) speaker volume respectively.
≥ No signal is output for the subwoofer. To adjust its
volume, see page 18, "Adjusting speaker level during
play".
3
Press [OK].
The test signal stops.
Complete
A Center (C)
B Test
C Left Surround (LS), Right Surround (RS)
To finish the speaker setting
Press [3, 4, 2, 1] to select "Complete" and press [OK].
VQT2T10
32
dB
)
0
ms
dB
C
L
0.0
0
R
dB
0
Test
SW
dB
ms
dB
0
0.0
0
LS
RS
Optional speaker settin gs
Speaker installation
option
Attaching to a wall
You can attach all of the speakers (except subwoofer) to a
wall.
≥ The wall or pillar on which the speakers are to be attached
should be capable of supporting 10 kg (22 lbs) per screw.
Consult a qualified building contractor when attaching the
speakers to a wall. Improper attachment may result in
damage to the wall and speakers.
≥ Do not attempt to attach these speakers to walls using
methods other than those described in this manual.
1
Drive a screw (not included) into the wall.
q)
A At least 30 mm (1
3
/
16
B ‰ 4.0 mm (
q)
5
/
32
C ‰ 7.0 mm to 9.4 mm (
9
/
D Wall or pillar
q to
E 5.5 mm to 7.5 mm (
7
/
32
2
Fit the speaker securely onto the screw(s)
with the hole(s).
Front speaker and surround speaker
Center speaker
q)
F 100 mm (3
15
/
16
q to
q)
3
/
32
8
q)
5
/
16
Hide quick links:
Advertisement
Table of Contents
