Network Setting Problems; Network Easy Setting - Panasonic SC-BT235 Operating Instructions Manual

Network Easy Setting

[BT730] [BT330] [BT230]
1
Select "Wired" or "Wireless" and press
[OK].
Network Easy Setting (Connection Check)
A settings check for home network and Internet connections
is now being conducted.
Please select a connection mode first.
Current setting : Wired
LAN cable connection:
Connect a LAN cable to the unit and select "Wired."
Wireless LAN connection:
Insert a compatible Wireless LAN Adaptor to USB port
and select "Wireless."
Access point is necessary for Wireless LAN connection.
Wired
Wireless
OK
RETURN
If "Wireless LAN Adaptor is not connected." is displayed, check
that the Wireless LAN Adaptor is fully inserted. Alternatively,
disconnect and reconnect it. If there is still no change in the
display, consult your dealer.
2
Follow the on-screen instructions and
make the settings with [3, 4] and press
[OK].
For wireless LAN connection:
If you are using a Wireless router (Access point) that supports
WPS, you can easily perform the settings by selecting "WPS
(PUSH button method)".
Otherwise, perform the settings by selecting "Search for
access point" or "Manual setting" in "Other methods".
Access Point Connection Setting
Select a connection method to use with an access point
of Wireless LAN.
Please refer to the operating instructions of the access
point about connection methods.
WPS (PUSH button method)
Other methods
p
OK
RETURN
≥ WPS (Wi-Fi Protected Setup) is a function that facilitates
settings relating to the connection and security of wireless
LAN devices. To see whether your Wireless router (Access
point) supports WPS, check the Wireless router operating
instructions.
[BT235]
Follow the on-screen instructions and make
the settings with [3, 4] and press [OK].
VQT2M13
20
Search for access point
WPS (PIN code method)
Manual setting
When you experience
problems with settings
[BT730] [BT330] [BT230] Access Point Connection Setting
Access Point Connection Setting
Failed to connect to the access point.
A conflict with another device occurred.
Do you want to configure Access Point Connection
Setting again ?
Yes No
OK
Display
A conflict with another
device occurred.
A time out error occurred.
An authentication error or a
time out error occurred.
A device error occurred.
Network Easy Setting (Connection Check)
Network Easy Setting (Connection Check)
Complete.
1. LAN cable connection : Fail
2. IP address setting : Fail
3. Connection to gateway : Fail
LAN cable is not connected.
Please check the connection.
Select "Yes" and press [OK] to check network
connection again. Select "No" and press [OK]
to finish Network Easy Setting.
Yes No
OK
Display
1. LAN cable connection or
Connection to access point
2. IP address setting
3. Connection to gateway
Check the following
≥ Please wait a few moments,
and then try again.
≥ Setting of the Wireless
router (Access point) for
MAC Address etc.
≥ The signal may be weak.
Using the USB extension
cable included with the
Wireless LAN Adaptor,
adjust the position of the
Wireless LAN Adaptor.
≥ The SSID* and the
encryption key of the
Wireless router (Access
point).
≥ Please wait a few moments,
and then try again.
≥ Connection of Wireless LAN
Adaptor
If there is no improvement in
symptom, contact our
Customer Service Center.
Check the
following
≥ Connection of
:Fail
the LAN
cables (
:Fail
:Fail
17)