Advertisement
2022-03-05 21:27 5/14
are included with the package of the
as a spare.
More information about the cable can be found in
Without properly connecting this cable, the battery will not show up on the display of the
The battery will also turn itself off.
It is important to ensure this connection and display of the battery on the
attempting firmware updates or settings changes on other devices if they depend on the power
supply from the battery. Without this connection, the battery may turn off unexpectedly.
4. GX Device Settings
On the
GX
device,
If your GX device has a BMS-Can port, the battery should be connected to this.
If you connect the BMS to the VE.Can port you will need to adjust the port speed. Select the
CAN-bus BMS (500 kbit/s) CAN-profile in the GX device. Menu path: Settings → Services →
VE.CAN port.
After properly wiring and setting the correct CAN-bus speed, the Pylontech will be visible as a battery
in the device list. If you have multiple batteries a single entry will show up, which represents all
batteries:
Next, go to Settings, DVCC, and configure as follows:
Venus Settings → System Setup Parameter Value
DVCC
Shared Voltage Sense
Shared Temperature Sense
For more information about the behaviour of DVCC, please see the
Note: The "Limit managed battery charge voltage" feature should be left OFF, unless you are
experiencing "High Voltage" or "Internal Error" alarms. These alarms can indicate that there is an
internal cell imbalance in the battery. It may be useful in this situation to enable this feature, and
then adjust the voltage limit down so that the batteries are able to balance charge without reaching
Victron Energy - https://www.victronenergy.com/live/
Victron & Pylontech UP2500, US2000, US3000, US2000C, US3000C, UP5000, Phantom-S, Force-L1 & L2
GX device
as an accessory, only one is used. Keep the other one
its
manual.
ON
OFF
OFF
GX device
GX
device.
GX device
display before
manual.
Advertisement
