Led Display; Eco/Gear Function (Some Units) - Rotenso SETU User Manual

SETU remote control
EN
REMOTE CONTROL SUPPORT
NOTE:
When the unit is off, press and hold MODE and SWING buttons together for one second, the louver will open for
a certain angle, which makes it very convenient for cleaning. Press and hold MODE and SWING buttons together for
one second to reset the louver (Model dependent).

7.3. LED display

Press LED button
Press this button to turn on and turn off the display
on the indoor unit.

7.4. ECO/GEAR function (some units)

7.4.1. ECO operation:
Under cooling mode, press this button, the remote controller will adjust the temperature automatically to
24°C/75°F, fan speed of Auto to save energy (only when the set temperature is less than 24°C/75°F). If the set
temperature is above 24°C/75°F, press the ECO button, the fan speed will change to Auto, the set temperature
will remain unchanged.
NOTE:
Pressing the ECO button, or modifying the mode or adjusting the set temperature to less than 24°C/75°F will stop
ECO operation.
Under ECO operation, the set tmeperature should be 24°C/75°F or above, it may result in insufficient cooling. If you
feel uncomfortable, just press the ECO button again to stop it.
26
User manual
LED
Press GEAR-ECO button to enter the energy efficient mode in a sequence of
following:
ECO GEAR(75%)
NOTE: This function is only available under COOL mode.
Press this button more than 5 seconds (some units)
Keep pressing this button more than 5 seconds,
the indoor unit will display the actual room
temperature. Press more than 5 seconds again will
revert back to display the setting temperature.
GEAR(50%) Previous setting mode
5s
LED
ECO......