Blockage - Automatic Shutdown - Pro-Aqua Homewing Instructions For Use Manual

BLOCKAGE – AUTOMATIC SHUTDOWN
The device is equipped with an automatic shutdown system. In the event of blockage,
the suction power is reduced and the device is automatically switched off.
Please follow the instructions below to clear the blockage caused by a clog.
1. Allow the device to cool down before searching for the cause of the blockage.
Do not operate the start switch during this time.
2. Make sure that the device has been disconnected from the charger before locating the
blockage. Failure to do so may result in injury.
3. Pay close attention to sharp objects while removing the blockage.
To inspect the product housing for blockages, remove the transparent dust container. You
may need to remove the brush roller to be able to remove the blockage. To do this, please
follow the following instructions:
1. Remove the brush roller according to the instructions in the
„Cleaning the brush roller" section.
2. Remove the cause of the blockage, such as dirt, lint, or
fibers, and then reinstall the brush roll according to the inst-
ructions in the „Cleaning the brush roller" section.
3. Make sure that the clasp has been turned completely and
that the base plate and the brush roller are properly atta-
ched before switching on the device.
4. Reassemble the device completely before operating it
again.
5. The removal of blockages is outside the scope
of the warranty.
EN
35