Cleaning The Brush Roller - Pro-Aqua Homewing Instructions For Use Manual

3. Clean the filter under clear running water until the water remains clear.
4. Lightly shake out the filter and let it dry for at least 24 hours.
5. Check that the filter is completely dry.
6. Replace the filter and turn it clockwise until it clicks into place.

CLEANING THE BRUSH ROLLER

34
Your device is equipped with a brush roller that must be
checked regularly to maintain it in accordance with the
following requirements. Make sure that the device has
been disconnected from the charger before removing the
brush roller.
Disconnect the electric brush from the suction tube. Do
not press the ON switch. Remove the brush roller, clean it
and then reinsert it following the instructions below.
1. Turn the cleaning head so that the lower part points
directly towards you. Using a coin, turn the clasp coun-
terclockwise a quarter turn until the clasp locks into the
unlock position.
2. Turn the end cover to the open position. Carefully pull
the brush roller out of the suction element.
3. Remove fibers, lint, dirt or dust by rubbing gently.
4. Fully insert the end of the brush roller into the correct
position. Push the brush roller back into the suction ele-
ment until it fully engages. Then, replace the end cover
on the brush roller.
5. Turn the clasp clockwise a quarter turn to close the end
cover. Make sure that the clasp is fully turned and the
brush roller is tight.