Table of Contents
Advertisement
Rea® Focus™
1. Remove the armrests and the seat cushion.
2. Loosen the two screws A.
3. Adjust the seat width.
4. Re-tighten the screws.
If the wheelchair is equipped with Flip-up armrests, the
following also needs to be done:
1. Loosen the screws B.
2. Re-tighten both screws A and the screws B
5 mm allen key
3.13 Adjusting the seat
C
1. Loosen the screw A.
2. Adjust the seat front B to the desired position.
Only adjust the seat front within the marked
area C. Max adjustment 5 cm
3. Re-tighten the screws again.
4. Repeat the procedure on the opposite side if necessary.
14
A
A
B
The seat front B can also be removed completely
if necessary.
Screwdriver
3.14 Leg rests
WARNING!
Risk of injury
– Never lift the wheelchair by the footrest
supports or leg rests.
CAUTION!
Risk of pinching or crushing fingers
There are swing mechanisms where you could
trap your fingers.
– Be careful when using, swinging, disassembling
or adjusting these mechanisms.
IMPORTANT!
Risk of damage to the leg rest mechanism
– Do not place anything heavy, or let children sit
on the leg rest.
3.14.1 Swing away leg rests
Swinging outwards
1. Activate the release lever A and swing the leg rests
to the outside.
Swinging forwards
1. Swing the leg rest forwards until it engages.
Unhinging
1. Activate the release lever A.
2. Pull the leg rest upwards.
Hinging
1. Hinge the leg rest on the front of the frame and swing it
forwards until it engages.
1431580-C
Advertisement
Table of Contents
