Test Connection; Status Connection - Toro TEMPUS-AG-4G User Manual

Toro TEMPUS-AG-4G
Step 4
LoRa

TEST CONNECTION

TM
If the association of the devices is carried out before the final installation of the TEMPUS-AG-4G, this connection test can be used to validate the positioning of
the latter by going to temporarily install the TEMPUS-AG-4G in its intended location then by going to position a device in each of the valve box to verify the good
communication with the TEMPUS-AG-4G.
The connection test can also allow you to verify at any time the correct operation of the LoRa
(Example: the product fell into the upside-down valve box and no longer communicates with the TEMPUS-AG-4G).
To test the LoRa TM connection, do the following:
1. Enter the TEMPUS-AG device
in Bluetooth®
If the connection is not established, a "No connection established" message appears. Repeat this test several times to confirm that the connection cannot be made.
In this case, the distance between the TEMPUS-AG-4G and the TEMPUS-AG device will need to be reduced.
LoRa

STATUS CONNECTION

TM
During the first installation it is necessary to charge the TEMPUS-AG-4G battery for 24 hours with 120VAC power before turning it ON.
Preamble :
• The communication periodicity in LoRa
The communication interval of the LoRa
can see the TEMPUS-AG-4G's power mode and its battery charge status in the table on the next page.
• Status of LoRa radio communication between the devices and the TEMPUS-AG-4G. These icons indicate when the TEMPUS-AG-4G was last connected to a
TM
device via LoRa TM .
Last connection < 24 hours
MS
Last connection > 24 hours
Changes not transmitted
Connection never done or very
long time without communication
with the gateway.
9
Then in the parameters
(small pencil at the top right)
mode :
TM
radio between the TEMPUS-AG(-xx) devices and TEMPUS-AG-4G is approximately 3 minutes (Battery full charged). You
TM
TM radio between your device and the TEMPUS-AG-4G.
2. Push on « Remote access »
TEMPUS AG 4G.
3. Push the red button to test
the connection LoRa
M
T
TEMPUS AG 4G.
4. The message indicate that the
TM
LoRa connection between the
TEMPUS-AG-4G and the device is
reliable.