Test Connection - Toro WiFi-LoRa TEMPUS-AG-WF User Manual

Toro TEMPUS-AG-WF
Step 4
TM
LoRa

TEST CONNECTION

If the association of the devices is carried out before the final installation of the TEMPUS-AG-WF, this connection
test can be used to validate the positioning of the latter by going to temporarily install the TEMPUS-AG-WF in
its intended location then by going to position a device in each of the valve boxes to verify good communication
with the TEMPUS-AG-WF. The connection test can also allow you to verify at any time the correct operation of
TM
the LoRa radio between your device and the TEMPUS-AG-WF.
(Example: the product fell into the upside-down valve box and no longer communicates with the TEMPUS-AG-
TM
WF). To test the LoRa
TEMPUS-AG-WF TEMPUS-AG CT4
TEMPUS-AG S1 TEMPUS-AG S4
1. Enter the TEMPUS-AG
device in Bluetooth®
If the connection is not established, a "No connection established" message appears. Repeat this test several
times to confirm that the connection cannot be made. In this case, the distance between the TEMPUS-AG-WF
and the TEMPUS-AG device will need to be reduced.
6
connection, do the following:
Then in the parameters
(small pencil at the top right)
3. Push the red
button to test the
connection LoRa
TM
2. Push on « Remote access »
4. The message indicate
TM
that the LoRa connection
between the TEMPUS-AG-WF
and the device is reliable
.