Sony KDL-26E4000 Operating Instructions Manual page 8

To tune the TV for Cable connection
1
Press .
2
F f
Press / to select "Quick Scan" or "Full
Scan", then press
"Quick Scan" : channels are tuned according to
the cable operator information within the
broadcast signal.
Recommended setting for "Frequency",
"Network ID" and "Symbol Rate" is "Auto".
This option is recommended for fast tuning
when supported by your cable operator.
If the "Quick Scan" does not tune, please use the
"Full Scan" method below.
"Full Scan" : All available channels are tuned
and stored. This procedure may take some time.
This option is recommended when "Quick Scan"
is not supported by your cable provider.
For further information about supported cable
providers, refer to support web site:
http://support.sony-europe.com/TV/DVBC/
3
f
Press to select "Start", then press
The TV starts searching for channels. Do not
press any buttons on the TV or remote.
~
Some cable providers do not support "Quick Scan". If no
channels are detected using "Quick Scan", perform "Full
Scan".
8
GB
.
.
Detaching the Table-
Top Stand from the TV
~
Do not remove the Table-Top Stand for any reason other
than to wall-mount the TV.
KDL-52W4xxx
KDL-46W4xxx
KDL-40W4xxx
KDL-40E4xxx
KDL-37V4xxx
KDL-26E4xxx
KDL-32W4xxx
KDL-32E4xxx
KDL-32V4xxx
KDL-26V4xxx