Sony KDL-22E5300 Operating Instructions Manual page 47

Condition
Changes on the server are not
being applied or displayed
content differs from content
on the server.
Photo, music and/or video
files do not appear or icons are
not displayed.
The TV cannot be found from
renderer-compatible device
(the controller).
Only a few icons appear under
the "Network" in the Home
Menu.
You have been using
registered Widgets, but now
some contents won't appear on
the Widgets.
General
Distorted picture and/or sound • Keep the TV away from electrical noise sources such as cars,
The TV turns off
automatically (the TV enters
standby mode).
The TV turns on
automatically.
Some input sources cannot be
selected.
The remote does not function. • Replace the batteries.
Explanation/Solution
• Sometimes changes are not applied to displays on the TV even though
content has been added and/or deleted on the server. If this happens, go
back up one level and try opening the folder or server again.
Preliminary Check
• Check that the connected device supports DLNA.
• Operations are not guaranteed for all servers. Also, operations differ
depending on the features of the server and the content in question.
• Turn the connected device on.
Check Connections
• Check that the LAN cable and/or mains lead/AC power cord of the
server has not become disconnected.
Check Settings
• Check that the connected device is registered under "Server Display
Settings" (page 27).
• Check that the server is correctly configured.
• Check that the selected device is connected to the network and can be
accessed.
• If the "IP Address Settings" in "Network" under "Network Settings" is
set to "DHCP (DNS automatic)" or "DHCP (DNS manual)", it may take
some time to recognise devices if there is no DHCP server. Execute
"Server Diagnostics" (page 27).
Check Connections
• Check that the LAN cable and/or mains lead of the server has not
become disconnected.
Check Settings
• Check if the "Renderer Function" is activated (page 40).
• Check that the connected device is registered under "Renderer Access
Control" (page 40).
• This is normal when internet connection is not available.
You can use three pre-installed Widgets properly. To enjoy more
Widgets, please check that the LAN cable and/or mains lead/AC power
cord of the router/modem has not become disconnected. (*)
• Check that the LAN cable and/or mains lead/AC power cord of the
router/modem has not become disconnected. (*)
• There's a possibility that the Widget Provider's server is out of service.
Please try using the Widget later.
(*) Your router/modem must be properly set to connect to the internet in
advance. Please contact your Internet Service Provider for the router/
modem settings.
motorcycles, hair-dryers or optical equipment.
• When installing optional equipment, leave some space between the
optional equipment and the TV.
• Check the aerial/cable connection.
• Keep the aerial/cable TV cable away from other connecting cables.
• Check if the "Sleep Timer" is activated, or confirm the "Duration"
setting of "On Timer" (page 29).
• Check if the "Idle TV Standby" is activated (page 29).
• If no signal is received and no operation is performed in the TV mode
for 30 minutes, the TV automatically switches to standby mode.
• Check if the "On Timer" is activated (page 29).
• Select "AV Preset" and cancel the "Skip" setting for the input source
(page 35).
47
(Continued)
GB