Texecom Premier Elite Impaq Plus-W Quick Start Manual

Hide thumbs Also See for Premier Elite Impaq Plus-W:

Press 1234 on the control panel. The below message will be displayed.

Press Yes

Press any free zone number (eg: 010) to learn your Impaq plus-W

Press reset button

When it starts learning you need to insert the battery into the Impaq plus-W

Press Yes

Technical Support

Premier Elite Impaq Plus-W (GBB0003)

till you reach zone type

91520 10269

Note: In this case

we're learning

sensor in zone 10.

Note: Before learning the

sensor we need to place

the jumper in relearn

 :

indiatechsupport@texe.com

Table of Contents

Need help?

Do you have a question about the Premier Elite Impaq Plus-W and is the answer not in the manual?

Page 1 Premier Elite Impaq Plus-W (GBB0003) Press 1234 on the control panel. The below message will be displayed. Note: In this case we’re learning sensor in zone 10. Press Yes Note: Before learning the sensor we need to place the jumper in relearn...
Page 2 Press Yes 7times to reach zone mode(wiring) & make zone wiring as “always awake” Press Menu ( ) two times on the control panel and then press Yes to logoff from your control panel Frequently Asked Questions: 1. How to enable reed? Ans: Inside the device we have an option for reed enable &...
Page 3 5. How to identify the LED status of sensor? Ans: Below are the detailed details of the LED status. Colour Status Description Flashing Comfort LED. When the reed switch is closed, the comfort Green LED will flash green approximately every 3sec to indicate correct operations.

Gbb0003