Auto-Tuning The Tv - Sony KDL-20B4030 Operating Instructions Manual

010COV.book Page 6 Friday, December 7, 2007 3:22 PM
4
Press F / f to select the country/region in
which you will operate the TV, then press
.
Auto Start Up
Language
Country
Location
Back:
Select: Confirm:
If the country/region in which you want to use the
TV does not appear in the list, select "-" instead of
a country/region.
5
Press F / f to select the location type in
which you will operate the TV, then
press .
Auto Start Up
Language
Country
Location
Back: Confirm:
Select:
This option selects the initial picture mode
appropiate for the typical lighting condition in
these enviroments.

5: Auto-tuning the TV

1
Before you start auto-tuning the TV, insert
a pre-recorded tape into the VCR
connected to the TV (page 4) and start play
back.
The video channel will be located and stored on
the TV during auto-tuning.
If no VCR is connected to the TV, skip this step.
2
Press .
Do you want to start automatic tuning?
Back:
Start:
The TV starts searching for all available digital
channels, followed by all available analogue
channels. This may take some time, so do not
6
GB
Home
Shop
Cancel:
MENU
press any buttons on the TV or remote while
proceeding.
If a message appears for you to confirm the aerial
connection
No digital or analogue channels were found.
Check all the aerial connections and press
start auto-tuning again.
3
When the Programme Sorting menu
appears on the screen, follow the steps of
"Programme Sorting" (page 26).
If you do not change the order in which the
analogue channels are stored on the TV, go to
step 4.
4
Press MENU to exit.
The TV has now tuned in all the available
channels.
~
When a digital broadcast channel cannot be received, or
when selecting a region in which there are no digital
broadcasts in step 4 (page 6), the time must be set after
performing step 4.
to