Mercedes-Benz SLS AMG Owner's Manual page 189

Features
186
Integrated garage door opener in the rear-view mir-
ror
Garage door remote control A is not part of
the integrated garage door opener.
i
To achieve the best results, insert new
batteries in garage door remote control
A before programming.
Before programming for the first time, clear
X
the memory of the integrated garage door
opener ( page 187).
Y
Select key position 2 with the Start/Stop
X
button.
Press and hold one of transmitter but-
X
tons ; to ? on the integrated garage door
opener.
After a short time, indicator lamp : starts
flashing yellow.
i
Indicator lamp : flashes yellow immedi-
ately the first time that the transmitter but-
ton is programmed. If this transmitter but-
ton has already been programmed, indica-
tor lamp : only starts flashing yellow after
10 seconds have elapsed.
Release the transmitter button.
X
Point transmitter button B of garage door
X
remote control A towards the transmitter
buttons on the rear-view mirror at a dis-
tance of 5 to 20 cm.
i
The required distance between garage
door remote control A and the integrated
door opener depends on the garage door
drive system. You might require several
attempts. You should test every position for
at least 25 seconds before trying another
position.
Press and hold transmitter button B on
X
garage door remote control A until indi-
cator lamp : lights up green.
The programming has been successful if
indicator lamp : lights up or flashes
green.
Release transmitter button ;, = or ? on
X
the integrated garage door opener and the
transmitter button on garage door remote
control B.
If indicator lamp : lights up red:
Repeat the programming procedure for the
X
transmitter buttons. When doing so, vary
the distance between the garage door drive
remote control and the rear-view mirror.
i
If the indicator lamp flashes green after
successful programming, the garage door
system is using a rolling code. After pro-
gramming, you must synchronise the
garage door opener integrated in the rear-
view mirror with the receiver of the garage
door system.
Synchronising the rolling code
Your vehicle must be within reach of the
garage door or exterior gate drive. Make sure
that neither your vehicle nor any persons/
objects are present within the sweep of the
door or gate.
Observe the safety notes when performing
the rolling code synchronisation.
Select key position 2 with the Start/Stop
X
button.
Press the programming button of the door
X
or gate drive (see the door or gate drive
operating instructions, e.g. under "Pro-
gramming of additional remote controls").
i
Usually, you now have 30 seconds to ini-
tiate the next step.
Press the previously programmed button of
X
the integrated HomeLink
®
garage door