Advertisement
Carefully remove all parts from the box.
1. Begin by first installing the Spout.
a. Remove the "T" Assembly (6,7) from the Spout (2).
b. Drop the Spout through the hole in your countertop or sink.
c. Tighten the Lock Nut (5) against the underside of mounting surface.
d. Re-assemble "T" Assembly onto bottom of Spout.
2. Identify your Hot and Cold Valves.
a. Remove all trim from Valve Assembly (including Lock Nut [11] where applicable), leaving
Bottom Lock Nut [12].
b. Push the valve from the bottom of the deck through the hole on the deck and thread the Lock
Nut [11] onto the valve. Make sure the top of the Lock Nut [4] is flushed with the end of
cartridge stem.
c. Put the entire handle trim [1] onto the Top Lock Nut [4], make sure the broached hole on the
handle engages with the cartridge stem.
d. Thread the handle escutcheon onto the top locknut [4] until it bottoms out to the deck.
e. Adjust position of handle then tighten the locknut on the valve.
3. Connect the two Flex Hoses (13) to "T" Assembly (7) and to the HOT (14H) and COLD (14C)
valves, respectively. These hoses can be bent or twisted but be careful not to kink the hoses
or you will have limited water supply and excessive noise from the faucet.
4. Begin by bleeding the water lines before connecting to the valves. Connect water supplies to
bottom of each valve.
5. Remove flow restrictors found in both inlets of "T" Assembly (7) and flush faucet by running
both Hot and Cold water in fully open position. Replace the flow restrictors.
6. Check for leaks. If leaks or problems occur, re-tighten all nuts before consulting a plumber.
23-2.18-SPT-ASSY
23-2.17-SPT-ASSY
23-2-SPT-ASSY
Loft – Widespread Lavatory Set
NOTE: The above instructions apply to the "A" handle trim.
Widespread Lavatory Set
Loft
Page 2
Advertisement
