Table of Contents
Advertisement
When the TV Remote
Control does not Work
When the bar speaker obstructs the
remote control sensor of the TV, the TV
remote control may not work. In that
case, enable the IR repeater function of
the system.
You can control the TV with the TV
remote control by sending the remote
signal from the rear of the bar speaker.
1
Press MENU.
[SPEAKER] appears in the front
panel display.
2
Press / to select [SYSTEM], then
press ENTER.
3
Press / to select [IR REPEATER],
then press ENTER.
4
Select [ON].
Notes
• Be sure to check that the TV remote
control cannot control the TV, and then
set [IR REPEATER] to [ON]. If it is set to
[ON] when the remote control can control
the TV, appropriate operation may not be
obtained because of the interference
between the direct command from the
remote control and command via the bar
speaker.
16
GB
/
MENU
ENTER
• Even if [IR REPEATER] is set to [ON], this
function may not work depending on
your TV. Also, the remote controls of
other devices such as an air conditioner
may not work correctly. In this case,
change the installation position of the
system or TV.
Advertisement
Table of Contents
