Kettler AQUA POWER 700 User Manual page 10

Assembly Instructions
STEP 2
Mounting Rower Seat and Upper Main Frame
REQUIRED
Left / Right Side Rail [2]
Rower Seat [3]
STEP 3
Mounting Rower Seat and Upper Main Frame
REQUIRED
Main Frame [1]
Side Rails Assembly [2]
16x M8 Washers [9]
8x M8 Standard Nuts [10]
8x M8 Nyloc Nuts [11]
8x M8x45mm Bolts [13]
CAUTION
Nyloc Nuts must be
outside the standard Nut
and Washer to properly
secure assembly.
Note: Clean Wheels and
tracks weekly with a soft
dry cloth in order to
decrease the rate of wear
on both Wheels and track.
Nyloc Nuts must be
outside the standard
Nyloc
Nut and Washer to
Nuts
properly secure assem-
bly.
To Install the Rower Seat, spread the Left/Right Side Rails[2]
slightly and drop the Rower Seat[3] into the track.
Note: Seat Indentation must face rearward.
Left/Right Side Rails
Next, install the Main Frame[1] onto the Side Rail Assembly[2] as
shown. You will need 8x M8x45mm Bolts[13], 16x M8 Washers
[9], 8x M8 Standard Nuts[10] and 8x M8 Nyloc Nuts[11].
Secure the front Lower Bracket first, then the Footboard but DO
2
NOT TIGHTEN. You may find that the Lower Bracket Bolts can be
difficult to access. You can tighten these bolts completely once
the Rower is standing in the vertical position so for the moment,
simply align and loosely thread lower Bolts/Nuts
Nyloc
Nuts
Rower Seat
10
Seat Indentation
.
Bolt Assembly Close Up
M8x45mm Bolt
M8 Washer
M8 Nyloc Nut
M8 Standard Nut