Installation and connection
en
Drainage into a plastic pipe
with rubber sleeve or into
a gully
Connecting
Alignment
Loosen the lock nut in a clockwise
1.
direction with a wrench.
Check the alignment of the washer
2.
dryer with a spirit level and, if
required, correct. Adjust the height
by rotating the appliance foot.
All four appliance feet must be
Note:
firmly on the floor.
The washer dryer must not wobble!
Tighten the lock nut against the
3.
housing.
Grip the foot and do not adjust the
height.
Notes
The lock nuts on all four appliance
■
feet must be screwed tightly against
the housing!
Any loud noises, intense vibrations
■
or "wandering" may be due to
incorrect alignment!
42
Electrical connection
Electrical safety
:
Warning
Risk of electric shock!
Danger of death if live parts are
touched.
When disconnecting the main plug,
■
always pull the plug itself and not the
cable, otherwise the cable could be
damaged.
Never touch or hold the mains plug
■
with wet hands.
Never pull out the mains plug during
■
operation.
Only connect the washer dryer to an
■
alternating current using a correctly
installed earthed socket.
The mains voltage must be the same
■
as the voltage specifications on the
washer dryer (appliance rating
plate).
The connected load and the required
■
fuse are also indicated on the
appliance rating plate.
Ensure that:
The mains plug and socket match.
■
The cable cross-section is adequate.
■
The earthing system has been
■
installed correctly.
A damaged power cord is only
■
replaced by an electrician.
A replacement mains cable can be
obtained from customer service.
You do not use multiple plugs/
■
couplings or extension cables.
If a residual-current-operated circuit
■
breaker is used, you use only a type
which features this symbol: z.
Only this symbol guarantees
compliance with the currently valid
regulations.
The mains plug is always accessible.
■
The power cord is not kinked,
■
crushed, altered or severed and has
not come into contact with any heat
sources.