Table of Contents
Advertisement
en
Trouble shooting
By hand:
Note:
You can use a special grease solvent for
stubborn dirt. It can be ordered via the Online Shop.
Soak the metal mesh grease filters in a hot soapy
■
solution.
Clean the filters with a brush and then rinse them
■
thoroughly.
Leave the metal mesh grease filters to drain.
■
In the dishwasher:
Note:
If the metal mesh grease filters are cleaned in the
dishwasher, slight discolouration may occur. This has
no effect on the function of the metal mesh grease
filters.
Do not clean heavily soiled metal mesh grease filters
■
together with utensils.
Place the metal mesh grease filters loosely in the
■
dishwasher. The metal mesh grease filters must not
be wedged in.
Installing the metal mesh grease filter
Insert metal grease filter.
1.
Fold up metal grease filter and engage the lock.
2.
Note:
Make sure that the filter lock engages properly.
Changing the activated charcoal filter (only in
circulating-air mode)
In order to guarantee efficient odour filtration, the filter
must be serviced regularly.
The activated charcoal filters must be replaced at least
every 4 months.
Notes
The activated charcoal filters are not included in the
■
delivery. The activated charcoal filters can be
obtained from specialist retailers, from our after-
sales service or from the Online Shop.
The activated charcoal filters cannot be cleaned or
■
reactivated.
Remove the metal grease filters; see above.
1.
Turn the old activated charcoal filters and pull them
2.
out of the retainer. ¨
Push the new activated charcoal filters into the
3.
retainer and turn. ©
Fit the metal grease filters; see above.
4.
8
3Trouble shooting
M alfunctions often have simple explanations. Please
T r o u b l e s h o o t i n g
read the following notes before calling the after-sales
service.
:
Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
Fault table
Problem
Possible cause
The appliance
The plug is not
does not work
plugged into the
mains
Power cut
The fuse is faulty
The lighting does
The LED lights
not work.
are defective.
--------
Solution
Connect the appliance to the
power supply
Check whether other kitchen
appliances are working
Check in the fuse box to make
sure that the fuse for the appli-
ance is in working order
You can read about this in the
section entitled "Replacing the
LED lights".
Advertisement
Table of Contents
