Appro LC-7553 Quick Start Manual

The 2.0-Megapixel IP Bullet Camera Indoor/outdoor (PoE)

Description of The Device

The PCB board:
6
1
1. Plug Inlet: An AC 24V inlet that connects to an external power supply.
2. ETHERNET 10/100 Connector: This is a standard RJ-45 connector for 10/100
Mbps Ethernet networks. PoE (Power over Ethernet) function: Provides power to
the device via the same cable as used for the network connection.
3. Plug Inlet: A DC 12V inlet that connects to an external power supply.
4. GPIO: This is a 6-PIN connector including the Digital output/input, DC output
and GROUND items for connecting with external devices.
5. VIDEO OUT Connector: The connector provides the unit's composite video
signals to a monitor. (This connector adjusts and improves the images.)
6. AUDIO IN: The connector is used to connect the audio output from other devices
to the camera.
7. USB port: The user can use a USB device cable to connect the IP camera to the
USB port on the PC.
8. AUDIO OUT: Provides the camera's audio signal to a speaker or stereo.
9. SD/ SDHC CARD slot: This is used for updating system software and archiving /
accessing critical images.
10. RESET: Recover to factory default.
7 8 9 10
2 3 4 5
The component parts ( the internal view ).
Dismantle the bullet IP camera to see its different parts. The picture here shows you
the internal component items making up the product.
SUN SHIELD
SD PCB
LENS FAN
SENSOR PCB
PCB PLATE
IR PCB
FRONT CASE
Camera with bracket ( the external view ).
The picture here shows the camera's exterior, with the bracket screwed in and fixed
to it. The bracket enables you to easily mount the camera on a wall, turned at the
angle you want.
NOTE: Use the 2 screws to screw the sun shield (above) into the 2 extreme holes indicated in the
bullet camera (below) to get an unobstructed viewing angle.
Please don't use the middle hole in the camera, as that will block the view.
1
SCREWS
REAR CASE
MIDDLE CASE
POWER PCB
WATERPROOF RUBBER
RMN0100560