Advertisement
MAINTENANCE
Vaniman blasters are designed to be low maintenance. However, as the materials used in a microblaster
are abrasive by design, components do wear out. A few minor areas should be maintained regularly
for a long product life.
Handpieces Hoses:
Check handpiece hoses for wear regularly. When hose feels thin or holes develop, the tubing should
be replaced. On the rear of the unit, where the handpiece hoses come through the cabinet, there is an
aluminum assembly that is a pinch valve for stopping and starting the media flow for the I/O option. This
will be the point of highest wear on the tubing. The hose can be slid back and forth in order to "wear"
a new section of hose. If a hole develops, replace the tubing.
Handpiece Tip Installation:
It is imperative that the handpiece tip and sealing o-ring be installed correctly and securely to avoid
damage or leaks. Install in the manner shown being sure the tip and o-ring seat evenly in the assembly.
1
Tanks:
When installing the lids on the tanks, be sure the lid is rid of any blasting material or debris. If the tank
or lid begins to wear, replace immediately. Do not overtighten the lid on the unit. The fittings on the
bottom of the tank are designed for easy maintenance of the hoses. To remove a handpiece tubing
from quick disconnect fitting, push toward the tank on the plastic ring while pulling the tubing out. Do
not remove the hose fittings while tank is full of media and upright; turn the tank upside down or empty
before removing hoses. To replace, be sure the fitting and hose are free of debris or abrasives and
push the hose firmly into the fitting. Be sure it goes in until you can see it through the clear wall of the
tank fitting. Improper installation will result in leakage and damage to the tanks.
NOTE: Do not remove the hose fittings while tank is full of media and upright; turn the tank upside down
or empty before removing hoses.
Moisture
Vaniman blasters include a Filter for small amounts of oil and moisture. If moisture causes the media
to clump or cake in the tanks, improper media flow will result. Be sure the air supply is relatively oil
and moisture free. An addition of the heavy duty air filter/dryer may solve the problem (See below for
ordering information).
140 N. Brandon
7
2
P.O. Box 74, Fallbrook, CA 92088
MOBILE SANDSTORM
4
3
5
1-800-VANIMAN (826-4626)
MOBILE SANDSTORM-I-09/14 Page 2
Fig. Reorder #
1
2192
2
2191
3
2187
4
2188
6
5
varies, #4
Included
6
2177
7
98109, #4
& #5 Not
Included
www.vaniman.com
Advertisement
