Vaniman SANDSTORM PRESTIGE I/O Quick Start Manual

1. CONDITIONS FOR USE
This micro abrasive blaster may only be operated:
• Indoors;
• Below 6500 ft above sea level altitude;
• Ambient air temperature between 40°-105°F (5-40°C);
• Maximum relative humidity of 80% at 88°F;
• Power supply current fluctuations does not exceed 10% of nominal value;
• Under level 2 contamination conditions;
• Supply cool, dry air only, at a maximum pressure of 150 PSI.
2. SAFETY
• Always disconnect the unit from the compressed air and power sources before beginning any
maintenance.
• When working with the tank wear protective glasses to protect your eyes.
• Any abrasive material on the o-ring may lead to leakage and early wear of the o-ring. After filling, clean the
thread and o-ring before applying the lid.
• Solvents will create cracks in the jar and weaken the jar (danger of explosion!). Clean the lid and tank only
with a dry cloth. Do not write or adhere anything to the jar or lid.
• Check for damages on the lids and tanks regularly and replace them if there is any doubt of the structural
integrity.
• Before operation, check to make certain the lid is secured properly. Using the product without the lid secured
will create a serious explosive hazard.
• Never operate the blasting units without suitable dust extraction and appropriate protective gear. The type
of dust extraction should be based on the type dust generated. Ask the proper authorities.
• Never direct the blasting material towards eyes or unprotected areas of skin. Improper use can result in risk
of eye or skin injuries.
• Never work with the glass door open.
• Caution: Failure to wear eye protection can result in eye injury. Wear proper eye protection to protect your
vision.
• Do not depress the foot switch when only the compressed air supply hose is connected. The loose hose could
wrap around itself and cause serious injury.
• Unplug the unit from the wall before changing out the LED light. Do not squeeze or bend the light tube. Always
wear gloves or use a towel to protect your hands from glass splinters.
• Inspect power cords before beginning operation. The unit may not be used if the power cord is damaged.
2.1 Liability Exclusion - Vaniman Manufacturing shall be absolved from all claims for damages and warranty if:
• The product is used for any purpose other than it was designed for.
• The product is altered in any way other than those described in the operating instructions.
• The product is repaired by any body other than an authorized facility or if any parts other than Vaniman OEM
parts are used.
• The product continues to be employed, despite obvious safety faults.
140 N. Brandon P.O. Box 74, Fallbrook, CA, USA 92088

1-800-VANIMAN (826-4626) USA

www.vaniman.com

SANDBLASTER SAFETY 7/15Page 1