Table of Contents
Advertisement
Chengdu Ebyte Electronic Technology Co,;Ltd
Applications
Note
6.7 Configuration Mode (Mode 5)
Status
M0=1 M1=0 M2=1
Transmitting
Transmission is not available. Serial data received are considered as configuration command.
Receiving
Receiving is not available.
Configuration
Parameter configuration can be made in configuration mode with specific instruction format and UART 9600, 8N1.
When entering other modes from configuration mode, the module will reconfigure parameters, AUX keeps low level
Note
during configuration;
After configuration completed, it outputs high level, so users are recommended to check the AUX rising edge.
6.8 Power Saving Mode (Mode 6)
Status
M0=0 M1=1 M2=1
Transmitting
Transmission is not available.
Receiving
Receiving is available.
Baud rate & air
Under this mode, the baud rate and air data rate are independent, both receiver and transmitter can have different
data rate
baud rate but same air data rate.
The module works under WOR status, it wakes up periodically and monitors the wireless data packets, when data
Advantage
packet monitored, the module enters receiving mode and receives complete data packets, and outputs the data
through serial port, and then enters WOR status again, which can save power consumption significantly.
Disadvantage
Transmission is not available under this mode, the module must be switched to other mode for data transmission.
Applications
Applicable for those devices which have requirement on power consumption and need to receive data.
Note
It can only receive the data sent from the transmitter under mode 4.
6.9 Sleep Mode (Mode 7)
Status
M0=1 M1=1 M2=1
Transmitting
Transmitting is not available.
Receiving
Receiving is not available.
Chengdu Ebyte Electronic Technology Co,;Ltd
Copyright ©2012–2021，
For waking up the receiver under WOR mode.
Under wake up mode, the single data packet length is 84 bytes (excluding the address and channel for
directional transmission).
E70-900T14S2 user manual
15
Advertisement
Table of Contents
