Connecting The Usb Cable - Fujitsu ScanSnap S510M Getting Started Manual

Use only the supplied AC cable and AC adapter
(power cable).
2. Insert the connectors of the AC adapter to the scanner
inlet, and then plug the cord in a power outlet.
Inlet

2.2.2. Connecting the USB cable

Follow the procedures below to connect the USB cable.
●
Use the USB cable supplied with this scanner.
ATTENTION
The operation with a commercially available
USB cable is not guaranteed.
●
When connecting to a USB hub, be sure to
connect the scanner to the hub nearest to your
computer (first stage). If you connect it to a USB
hub from the second stage onwards, ScanSnap
may not operate correctly.
●
If you connect the scanner with USB 2.0, it is
required that the USB port and the Hub are
compliant with USB 2.0. The scanning speed
may slow down when you connect the scanner
with USB 1.1. If your computer has the USB 2.0
compatible port, use it.
1. Remove the seal from the USB connector.
2. Connect the scanner and your computer with the USB
cable.
USB cable
3. Open the Paper chute of the scanner.
If the scanner does not turn on automatically,
ATTENTION
press the [POWER] button on the scanner.
Your computer will automatically detect the scanner.
8 |
The installation of ScanSnap is complete!
ATTENTION
Outlet
HINT
The ScanSnap Manager icon
below the icon appears in the Dock menu.
When the icon remains inactive
[POWER] button to turn off the scanner, and then
press the [POWER] button again to restart the
scanner. (Allow at least 5 seconds when you turn
on/off the scanner.)
When using the [POWER] button to turn off/on the
scanner, press it for longer than one second.
* To prevent miss-operation, the [POWER] button
does not work unless it is pressed for longer than
one second.
with a triangle
, press the