Siemens CT836LEB6W Instruction Manual page 51

F
Important:
Before starting each service program
(Descale, Clean or calc'nClean)
remove the brewing unit, clean as
instructed and replace it.
Be careful not to jam the milk tube
when closing the door.
After completion of each service
programme, wipe the appliance
immediately with a soft, damp cloth
to remove any residues from the
descaling and cleaning solution. It is
possible for corrosion to form under-
neath such deposits.
New sponge cloths may contain
salts. Salts can cause rust film on
stainless steel and must therefore be
washed out thoroughly before use.
Clean the beverage outlet, milk tubes
and connecting piece thoroughly.
Specially developed, suitable
descaling and cleaning tablets are
available from retail outlets or from
customer services (see the section
"Accessories").
F
Using a water filter increases the
intervals until a descaling pro-
gramme needs to be performed.
Descaling
Takes about 21 minutes.
■ Press button t.
■ Turn the rotary selector to select
"Descale".
■ Press button u. Display indicates
progress of the programme.
■ Empty drip trays and replace.
■ Remove water filter(if there is one) and
press u.
■ Pour lukewarm water into the empty
water tank up to the "0.5 l" mark and then
dissolve one Siemens descaling tablet
TZ80002 in it.
Service programmes
F
If there is not enough descaling
solution in the water tank, you will
be asked to do the following. Refill
using uncarbonated water and press
u again.
■ Remove the suction pipe from milk
container, wipe it and insert the end of the
suction pipe into the hole on the coffee
grounds container.
■ Close the appliance door.
■ Place a container with a capacity of
0.5 litre under the beverage outlet.
■ Press button u. The descaling
programme will now run for about
19 minutes.
■ Remove the container and press
u.
■ Rinse the water tank and (if removed)
replace the water filter.
■ Fill the tank with fresh water up to the
"max" indicator.
■ Replace the water tank and close the
door.
■ Place the container underneath the
beverage outlet again.
■ Press button u. The descaling pro-
gramme will now run for about 2 minutes
and rinse the appliance.
■ Remove the container, empty the drip
trays, replace and close the appliance
door.
■ Press u. The appliance has
finished descaling and is ready for use
again.
■ Press t to exit the program.
Cleaning
Takes about 5 minutes.
■ Press button t.
■ Turn the rotary selector to select "Clean".
■ Press button u. Display indicates
progress of the programme.
■ Clean the beverage outlet and replace,
empty the drip trays and replace.
■ Open the ground coffee drawer, drop in
a cleaning tablet and close the coffee
drawer again.
■ Close the appliance door.
en
51