Fujitsu ScanSnap fi-5110EOXM Getting Started page 19

5. Remove the Pick roller with its shaft.
Hold the left part of the shaft, and raise it to remove
the shaft from the scanner while pulling the shaft to
the left.
Pick roller shaft
If the around the pick roller is dirty by paper
ATTENTION
-powder, it may cause a scanning error.
Please remove the dirt using a dry cloth with
dollop of Cleaner F1.
* Don't use water, mild detergent or air-spray.
6. Remove the Pick roller from the shaft.
Pull out the shaft from the Pick roller while lifting up
its tab.
Tab
it may crack or chip your fingernail.
ATTENTION
If you worry about that, push up the pick roller
tab using a paper clip.
7. Attach the new Pick roller to the shaft.
Insert the new Pick roller aligning the protrusion with
the slot on the Pick roller.
Shaft
Pick roller
Shaft
Pick roller
1
2
Pick roller
Groove
Protrusion
ScanSnap fi-5110EOXM for Macintosh Getting Started | 17
8. Install the Pick roller with its shaft into the scanner.
and set the shaft to the slot while lowering it.
Shaft
9. Fix the Pick roller bushing (left) by rotating it in the
direction of the arrow.
Pick roller bushing
Pick roller
Make sure that the Pick roller is
ATTENTION
completely attached and correctly
installed. Otherwise, document jams or
other feeding errors may occur.
10. Attach the sheet guide to the scanner.
While holding the handle on the sheet guide, set the sheet
guide into the scanner.
Sheet guide
You should hear the sheet guide click when it
returns to its original position.
Bushing
Pick roller
Shaft
Handle
Craw