Panasonic CF-AX3 Series Operating Instructions Manual page 33

4 <Only for model with TPM> Clear TPM.
A Click on the Start screen.
B Click [Run] under "Windows System", input [tpm.msc] and click [OK].
C Click [Clear TPM...] under "Actions" on the right of the "TPM Manager on Local Com-
puter" screen.
D Click [Restart] of the "Manage the TPM security hardware" screen.
The computer will restart.
E When "TPM configuration change was requested to ..." is displayed, press F12 .
F Click the Desktop tile, and when "TPM is ready" appears, click [Close].
„ Hard Disk (Flash memory) Recovery
CAUTION
l If the recovery partition is deleted, you cannot perform hard disk (flash memory) recovery.
Preparation
l Change to the laptop mode.
l Remove all peripherals.
l Connect the AC adaptor and do not remove it until installation is complete.
If reinstallation using the method described in "Remove everything and reinstall
Windows" above is not successful, follow the steps below.
1 Start the Setup Utility.
A Display "Charm", and click
B Click [Restart now] under "Advanced startup".
C Click [Troubleshoot] - [Advanced options] - [UEFI Firmware Settings] - [Restart].
Turn on the computer, and press F2 or Del while [Panasonic] boot screen is displayed.
l If the [Panasonic] boot screen is not displayed, turn on the computer while holding down
F2 or Del .
l If the password is requested, enter the Supervisor Password.
2 Write down all of the contents of the Setup Utility and press
At the confirmation message, select [Yes] and press Enter .
3 Check the [UEFI Boot] setting of the Setup Utility.
[UEFI Boot] should be set to as follows.
When Windows 8.1 is used: [Enabled]
When Windows 7 is used: [Disabled]
4 Press .
F10
At the confirmation message, select [Yes] and press Enter .
Computer will restart.
5 Press or
F2
The Setup Utility starts up.
l If the password is requested, enter the Supervisor Password.
6 Select the [Exit] menu, then select [Recovery Partition] and press
7
Click [Next] and click [YES].
Click [Reinstall Windows] and click [Next].
- [Change PC settings] - [Update and recovery] - [Recovery].
while [Panasonic] boot screen is displayed.
Del
F9 .
.
Enter
33