Bosch KGN33NL20G Instructions For Use Manual page 21

Fault
Warning signal sounds.
Temperature display flashes.
Fig. "/3
The temperature in
the freezer compartment is
too warm.
The light does not function.
Controls have reduced
luminosity.
Displays do not illuminate.
Appliance is not cooling,
temperature display and light
are lit.
Possible cause
Fault - the freezer
compartment is too warm!
Frozen food is at risk.
Appliance is open.
Ventilation openings have
been covered.
Too much food was placed in
the freezer at once.
Appliance opened
frequently.
The ventilation openings
have been covered.
Large quantities of fresh
food are being frozen.
The LED light is defective.
Appliance was open too
long.
Light is switched off after
approx. 10 min.
When the appliance is not
used for some time,
the display on the fascia
switches to energy saving
mode.
Power failure; the fuse has
been switched off; the mains
plug has not been inserted
properly.
Showroom mode is
switched on.
Remedial action
To switch off the warning signal, press the
temperature setting button, Fig. "/1.
Close the appliance.
Ensure that there is adequate ventilation.
Do not exceed max. freezing capacity.
When the fault has been rectified, the
temperature display stops flashing.
Do not open the appliance unnecessarily.
Remove obstacles.
Do not exceed max. freezing capacity.
See chapter "Light (LED)" section.
When the appliance is closed and opened,
the light is on again.
As soon as the appliance is again used, e.g.
the door is opened, the display switches back
to normal illumination.
Connect mains plug. Check whether the power
is on, check the fuses.
Hold down temperature selection button
fig. "/1 for 10 seconds until
an acknowledgement signal sounds.
After a short time check whether your
appliance is cooling.
en
21