Exit Menu - Leaving The Setup Utility - Fujitsu LIFEBOOK LH531 Bios Manual

EXIT MENU – LEAVING THE SETUP UTILITY
The Exit Menu is used to leave the setup utility. Follow
the instructions for Navigating Through the Setup
Utility to make any changes. (See Navigating through
the Setup Utility on page 2 for more information.)
Info System
Exit Saving Changes
Exit Discarding Changes
Load Setup Defaults
Discard Changes
Save Changes
Save Changes and Power Off
F1 Help
ESC Exit
Table 8: Fields, Options and Defaults for the Exit Menu
Menu Field Description
Exit Saving Exit Saving Changes and Exit will store all the entries on every menu of the setup utility to the BIOS memory, then exit
the utility. A confirmation message Save Configuration changes and exit now? [Yes][No] is displayed.
Changes
Exit Discarding Selecting Exit Discarding Changes and Exit will exit the setup utility without writing to the BIOS memory. When the
Changes BIOS recognizes this selection it will reboot, load the operating system and begin operation.
Load Setup Selecting Load Setup Defaults will load the factory preset default values for all menu fields, then display the message
Load default configuration now? [Yes] [No]. When confirmed the setup utility will return to the Exit
Defaults
Menu. To return to another menu follow the directions in the Navigating Through the Setup Utility Section.
Selecting Discard Changes will load the previous values in BIOS memory for all menu fields. The message Load
Discard
previous configuration now? [Yes] [No] will be displayed. When confirmed the setup utility will return to
Changes
the Exit menu. To return to another menu, follow the directions in the Navigating Through the Setup Utility Section.
Selecting Save Changes will cause the new settings in all menus to be written to the BIOS memory. The message Save
Save Changes
configuration changes now? [Yes] [No] will be displayed. When confirmed, the setup utility will return to
the Exit menu. To return to another menu, follow the directions in the Navigating Through the Setup Utility section.
Save Changes Selecting Save Changes and Power Off will cause the new settings in all menus to be written to the BIOS memory. The
message Save configuration changes and power off now? [Yes] [No] will be displayed. When con-
and Power Off
firmed, the system will shut down. If No is selected, the system will return to the Exit menu. To return to another menu,
follow the directions in the Navigating Through the Setup Utility section.
Phoenix SecureCore(tm) Tiano Setup
Advanced Security
Select Item
-/Space
Select Menu
Enter
Figure 8. Exit Menu
The following table shows the names of the menu fields
for the Exit menu, the default settings and a description
of the field's function and any special information
needed to help understand the field's use.
Boot Exit
Change Values
Select Sub-Menu

E x i t M e n u
Item Specific Help
Exit System Setup and
save your changes to
CMOS.
F9 Setup Defaults
F10 Save and Exit
13