Gravely Promaster 160 Owner's/Operator's Manual page 16

Hide thumbs Also See for Promaster 160:
Table of Contents

Advertisement

5. Lubricate rubber gasket on new oil filter with clean
hydraulic oil.
6. Spin new oil filter onto filter housing until it makes
contact. Tighten oil filter another 1/2 turn.
7. Add new oil to the oil tank. It will take about 4 quarts.
Use Mobil 1 Extended Performance 15W50 synthetic
oil for best pump and wheel motor life.
8. Properly dispose of waste oil.
MOWER BLADES
Remove
CAUTION: Use sturdy gloves or padding to protect
hands when working with mower blades.
1. Turn the engine off. Remove the ignition key. Remove
the ignition wire from the spark plugs.
2. Block mower blades to prevent rotation.
3. Remove the bolts, washers, and blades from the
spindle shafts.
Replace
1. Replace the blades, washers and bolts on the spindle
shafts.
2. Tighten the bolts to a torque of 115-125 lbf-ft
(156-169 N•m).
3. Replace the ignition wire on the spark plugs.
Sharpen the Mower Blades
CAUTION: DO NOT sharpen mower blades while
on unit. An unbalanced mower blade will cause
excessive vibration and eventual damage to unit.
Check mower blade balance before reinstalling
blades.
NEVER weld or straighten bent blades.
1. Remove mower blade from unit.
Discard mower blade if:
• More than 1/2 in. (1.27 cm) of metal is removed.
• Air lifts become eroded.
• Blade is bent or broken.
Figure 7
2. Sharpen mower blade by removing an equal amount of
material from each end of mower blade. DO NOT
change angle of cutting edge or round the corner of the
mower blade.
3. Check mower blade balance.
Slide mower blade on an unthreaded bolt. A balanced
blade should remain in a horizontal position. If either
end of mower blade moves downward, sharpen the
heavy end until blade is balanced.
4. Install mower blade(s) on unit.
5. Tighten the bolts to a torque of 115-125 lbf-ft
(156-169 N•m).
DO NOT Sharpen to This Pattern
2
DISCARD if More
Than 1/2 in. (1.27 cm)
3
4
1. Cutting Edge
2. Square Corner
BATTERY
WARNING: AVOID INJURY. Read and understand
entire Safety section before proceeding.
WARNING: Battery posts, terminals and related
accessories contain lead and lead compounds,
chemicals known to the State of California to cause
cancer and reproductive harm. Wash hands after
handling.
Unit comes equipped with a maintenance-free battery that
requires no regular maintenance except cleaning the
terminals.
GB - 16
4
Sharpen to This Pattern
3. Air Lift Erosion
4. Air Lift
Figure 8
1
1
OT0792

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents