Cutting system servicing
Frequency of replacement of cutting system components for normal use.
TR807C53E
TR807C53E
Chain guide maintenance
Accumulation of dirt
Grease
All other appearance defects or wear
A guide suffers the most wear in the place most often used for cutting. To have the most
consistent possible wear, it is recommended to turn the guide over often. To remove and
refit the chain guide, refer to the "Replacing the chain or chain guide" section.
20
TR805P11
TR807G53
Length 8"
Gauge 0.043"
Seepage
Wear
Guide sprocket
TR807C53E
TR807C53E
TR805P11
TR807G53