Accessory Parts; Installation Of R32 Refrigerant Air Conditioner - Toshiba RAV-GP801AT-E Instruction Manual

2

ACCESSORY PARTS

Part name Q'ty
Installation manual 1
CD-ROM 1
Drain nipple 1
Waterproof rubber cap 5
Protective bush 1
Guard material for passage part 1
Clamp filter 1
EN-147
Shape Usage
Hand this directly to the customer.
(For other languages that do not appear in this
Installation Manual, please refer to the enclosed
CD-R.)
— Installation manual
Type A (4 pcs.)
Type B (1 pc.)
For protecting wires (pipe cover)
For protecting passage part (pipe cover)
For conforming to EMC standards (for GM80
type)
3
INSTALLATION OF R32 REFRIGERANT AIR
CONDITIONER
CAUTION
R32 refrigerant air conditioner installation
• This air conditioner adopts the HFC refrigerant (R32) which does not destroy ozone layer.
Therefore, during installation work, make sure that water, dust, former refrigerant, or refrigerant oil does not enter the
R32 refrigerant air conditioner cycle. To prevent mixing of refrigerant or refrigerant oil, the sizes of connecting sections
of charge port on the main unit and installation tools are different from those of the conventional refrigerant units.
Accordingly, special tools are required for the R32 or R410A refrigerant units. For connecting pipes, use new and
clean piping materials with high pressure fittings made for the R32 or R410A only, so that water and/or dust does not
enter.
• When using existing piping, refer to "15 APPENDIX - [1] Existing piping".
Required Tools/Equipment and Precautions for Use
Prepare the tools and equipment listed in the following table before starting the installation work.
Newly prepared tools and equipment must be used exclusively.
Legend
: Conventional tools (R32 or R410A)
: Prepared newly (Use for R32 only)
Tools / equipment
Gauge manifold
Vacuuming / charging
refrigerant and operation check
Charging hose
Charging cylinder Can not be used
Gas leak detector Charging refrigerant
Vacuum pump Vacuum drying
Vacuum pump with backflow
Vacuum drying
prevention function
Flare tool Flare machining of pipes
- 74 -
Use How to use tools / equipment
Conventional tools (R410A)
Conventional tools (R410A)
Unusable (Use the electronic refrigerant charging
scale)
Conventional tools (R32 or R410A)
Conventional tools (R32 or R410A)
Usable if the backflow prevention adapter is
installed.
Conventional tools (R32 or R410A)
Conventional tools (R410A)
EN-148