Removing Expresscards - Fujitsu Lifebook E8410 User Manual

See your ExpressCard manual for instructions on the installation of your card. Some cards may require
that your notebook is off while installing them.
To install an ExpressCard, follow these steps:
1
Make sure there is no ExpressCard currently in the slot. If there is, see Removing ExpressCards.
2
If the eject button is extended, press it in until it clicks.
3
Insert your ExpressCard into the slot with the product label facing up. If you are inserting a 34 mm card, be sure
to align it with the left side of the slot when inserting it.
4
Push the card firmly into the slot until it is seated in the connector.

Removing ExpressCards

See your ExpressCard manual for specific instructions on removing your card. Some cards may
require your notebook to be in Standby Mode or Off during removal.
•
W
INDOWS HAS A SHUTDOWN PROCEDURE FOR
A CARD
TO REMOVE DEVICES USING THE
•
I
F THE DIALOG BOX STATES THAT THE DEVICE CANNOT BE REMOVED
CLOSE ANY OPEN APPLICATIONS AND SHUT DOWN YOUR NOTEBOOK
To remove an ExpressCard, follow these steps:
1
Unlock the card from the slot by pressing the eject button associated with the slot in which the card is located.
When pressed, the button will pop out.
2
Firmly press the button again until it is flush with the notebook. This will eject the card slightly out of the slot
allowing you to remove the card.
. (R
EVIEW YOUR OPERATING SYSTEM MANUAL FOR THE CORRECT PROCEDURE
S
AFELY
84 - PC Cards/ExpressCards™
E C
XPRESS ARDS THAT MUST BE FOLLOWED BEFORE REMOVING
R H
EMOVE ARDWARE ICON IN THE SYSTEM TRAY
,
YOU MUST SAVE ALL OF YOUR OPEN FILES
.
.) I
T IS GOOD PRACTICE
.
,