Fujitsu Lifebook E8410 User Manual page 117

Problem
The display goes blank by
itself after you have been
using it.
(continued)
Your display won't turn on
when the system is turned
on or when it has resumed.
The Built-in Display does
not close.
The Built-in Display has
bright or dark spots.
The application display
uses only a portion of your
screen and is surrounded
by a dark frame.
Possible Cause Possible Solutions
The power manage- Press any button on the keyboard, or move the mouse to restore
ment timeouts may be operation. If that fails, push the Power/Suspend/Resume button.
set for very short inter- (The display may be shut off by Standby Mode, Auto Suspend or
vals and you failed to Video Timeout)
notice the display come
on and go off again.
The system may be Check the status indicator panel to verify that the Security icon is
password-protected. blinking. If it is blinking, enter your password.
A foreign object, such Remove all foreign objects from the keyboard.
as a paper clip, is stuck
between the display and
keyboard.
If the spots are very tiny This is normal; do nothing.
and few in number, this
is normal for a large
LCD display.
If the spots are numer- Display is faulty; contact your support representative.
ous or large enough to
interfere with your oper-
ation needs.
You are running an Display compression gives a clearer but smaller display for appli-
application that does cations that do not support 800 x 600/1024 x 768 pixel resolution.
not support 800 x You can fill the screen but have less resolution by changing dis-
600/1024 x 768 pixel play compression settings, (See Video Features submenu located
resolution display and within the Advanced menu of the BIOS. See "BIOS Setup Utility"
display compression is on page 54.
enabled.
112 - Troubleshooting Your LifeBook