Advertisement
Grinding bits and chisels
1. Protective shield for additional safety
2. Powerful built-in magnet to hold the blade
3. Adjustable grinding angle from 20° to 40°
4. Guide for small chisels
Grinds bits and chisels up to a width of 50 mm (2").
1. Slide the module marked "Chisel & Plane Sharpener" onto the power unit.
2. Place the tool so that the blade points towards the edge of the disc (3a). The magnet helps you
holding the tool.
3. The grinding angle needs to match the present bevel angle of the point of the blade. If neces-
sary, re-adjust.
4. To re-adjust the angle, un-tighten the angle button (3c), adjust the angle of the plate, then re-
tighten.
5. Make sure that the blade of the tool touches the grinding disc, then switch the device on.
6. Swivel the blade over the grinding disc, exerting a slight, uniform, and uninterrupted pres-
sure (3d), otherwise, the blade is sharpened unevenly.
7. Gradually slide the blade downwards on the grinding disc while grinding (3e). Do not exert too
high a pressure, grind stepwise, and repeat step 6.
8. Remove the blade, making sure that the edge chamfered and the point have been evenly sharp-
ened. Otherwise, re-adjust the grinding angle. It is important that the bevel grinding angle and
the angle of the blade present match. Hereby, you will avoid that too much metal is removed
and make sure that the blades keep their optimal shearing angle (3f).
9. If grinding small chisels, set the appropriate guide to the spacer plate and sharpen as described
above (3g).
10. Switch the power off. Before removing the module, make sure that the grinding disc has come
to a standstill.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 51251
Page 7
09
2021-1
Advertisement
