Floppy Disk Drive Problems; Hard Drive Problems - Fujitsu Lifebook C2220 User Manual

Brie3-B5FH-8711.book Page 77 Wednesday, May 14, 2003 10:37 AM
Problem
The media player will The region code for the DVD
not play international does not match that of the media
DVD titles player.
The LifeBook notebook The media player software has
fails to Auto-Play a DVD not been installed.
movie.

Floppy Disk Drive Problems

You cannot access your You tried to write to a write
floppy disk. protected floppy disk.
Floppy disk is not loaded
correctly.
BIOS setup utility states Floppy
Disk Controller:
Disabled.
Security is set to protect access to
floppy disk data.

Hard Drive Problems

You cannot access your The setup utility is incorrectly set
hard drive. for your internal (Primary
Master) or optional second hard
drive (Primary Slave).
The wrong drive designator was
used by an application when a
bootable CD-ROM was used to
start the LifeBook notebook.
You cannot access your Security is set so your operating
hard drive. (continued) system cannot be started without
a password.
Possible Cause
All Fujitsu notebook DVD players are set to play
DVD titles with region code number 1, which is
specified for the North American market. The
region number is a regional restriction code defined
by the DVD Forum acting on the requirements of
Hollywood. Different region codes are recorded on
video DVD titles for publication in different areas of
the world. If the regional code of the DVD player
does not match the regional codes on the titles, then
playback is impossible.
NOTE: You can change the region code on the DVD
player using the Properties menu of the DVD soft-
ware. Note, however, that you can only change the
region code up to four times. After the fourth
change, the last region code entered becomes
permanent, and cannot be changed.
Locate and install the DVD-ROM Applications CD.
Eject the floppy disk and set it to write enable. (See
Internal Floppy Disk Drive on page 37 for more infor-
mation)
Eject floppy disk, check orientation and re-insert.
(See Internal Floppy Disk Drive on page 37 for more
information)
Revise the setup utility Main menu settings to
enable Diskette Controller. (See BIOS Setup Utility
on page 27 for more information)
Verify your password and security settings.
Revise BIOS settings to set both Primary Master
and Primary Slave correctly. (See BIOS Setup Utility
on page 27 for more information)
Verify drive designator used by application is in
use by the operating system. When the operating
system is booted from a CD, drive designations
are automatically adjusted.
Verify your password and security settings.
T r o u b l e s h o o t i n g
Possible Solutions
77